-
CMAF or CMEF
Description
The EPTA® CMAF pneumatic level switch is used to control in oil and gas production and in industries of processes in general. Because of its design is used efficiently in containers used to measure liquids, in two phase separators (liquid-gas), and as alarms of high and/or low level.
The main characteristic of this equipment is its quick drive and that it provides an exact and repetitive control signal.
MODELS: CMAF with valve MV777 EPTA®
CMEF with electric micro-contact -
INE2800-252V
Description
The INE2800-252V electric level switch is an equipment used in control in the oil industry, and for other industrial uses. It consists of a micro switch inside an explosion-proof box type 2800 with a displacer and a flex tube type 252V. -
Line CN2900
Description
The pneumatic level controller CN2900 is a reliable and strong-built equipment used for the detection of the level of liquid.
It is used in pressurized containers or non-pressurized. It is specially useful for the gas and oil industry, and for industrial processes in general. -
Line CN2500
Description
The EPTA® CN2500 level pneumatic controller has two main elements: the controller and the displacer. There is equipment for interface liquid-liquid with superior liquid density emulsion oil-water 0,925 g/cm³; lower liquid water: 1,02 g/cm³. -
Line CP4150/4160
Description
The pneumatic pressure controller CP4150 y CP4160 has a primary element (Bourdon tube and/or bellows) which connected to the pressure that must be controlled, transforms the variations of that pressure into a pneumatic signal using a system based on the balance principle using a nozzle, a flap and readjustment bellows. This signal is amplified in stream and pressure by a pilot which produces the output signal. -
PN3582
Description
The pneumatic positioner PN3582 is an instrument used to control pneumatic control globe valves, butterfly valves, moto-levers or other devices operated by a pneumatic signal.
The positioner is also used as an element to connect a controller and a pneumatic actuator so as to secure the correct position of the stem of the actuator (or the valve) proportional to the signal received from the controller (4150/4160) -
Line RP1301
The EPTA® RP1301 high pressure reducers are used in pressure reducing valves, control panels, control valves and instruments type fail close (FC) or fail open (FO), etc.
The pressure reducers, RP1301 EPTA®, are used when there is high inlet pressure (depending on the construction material) and a it is needed a high outlet of the fluid with a constant reduced pressure.
The reducers can have a heating chamber incorporated. -
Line RP1305
The EPTA® RP1305 high pressure reducer is used to avoid hydrates to appear when there are big increases in pressure. This regulator is used for services with natural gas, air or propane and other gases that are not aggressive to the construction materials.
The reducer expansion point is inside the flow tube of the fluid which pressure we try to reduce. Therefore, as the temperature of the gas in the tube is relatively high, the formation of hydrates in that point of expansion are prevented.
